Compressibility and recovery tester

उत्पाद विवरण

The ASIAN Compressibility and Recovery Tester of Gasket Material Consist of an Anvil- A
hardened and ground surface on which the sample is placed. There are a set of steel cylindrical shape
penetrators of specified sizes and shape according to the material test (as per Table 1). There are two LVDT
also mounted on the anvil for the measurement of the thickness of the test specimen at the time of preloading
and the total load. There are two LVDT so that by taking the average value you can measure the accurate
thickness.
There is the software which manages the machine as per related standards.
Preload A preload which shall include the weight of the penetrator itself and added weight of the
penetrator itself and added weights to give the value specified within 1%. Preloads for various types of gasket
materials are as shown in Table 1, unless otherwise specified.
There is a selection for the setting of load conditions as given below.
Mode 1= pre-load 22.2 N & total load 1112 N
Mode 2= pre-load 4.4 N & total load 222 N
Mode 3= pre-load 4.4 N & total load 356 N
purpose as per modes always use auto mode and for the movement of the penetrator always use manual. In
manual mode for up and down movement first of all press the rotary switch for the up or down position and
than in manual mode.
All the parts are either painted/powder coating chrome plating for corrosion resistance long life.
TECHNICAL DATA
LVDT : 0 to 10 mm X 0.001 mm least count
Load cell : 1500 N
Motor : Hp induction motor
Power requirements : 500 W, 220 VAC single phases
RELATED STANDARD
ASTM F 36 (1500 N)